Bird FeederWeb

Pressure-treated wood for bird feeders

The rule comes from the people who make the wood, and it did not change when arsenic left the lumber yard. It decides the tray, not the post.

·7 min read

The short answer

  • Do not use pressure-treated wood for any part of a feeder that touches seed: the tray floor, the hopper ledge, the walls the seed sits against. The industry's own safety sheets say not to use it where the preservative may become part of food or animal feed.
  • A treated post or deck rail that only holds a feeder up is fine on that rule, as long as the seed never sits on the treated wood.
  • Today's copper treatments (ACQ, copper azole, micronized copper) carry the same food and feed line as the old ones. Taking arsenic out of home lumber did not change the rule.
  • Wood from a deck or fence built before 2004 may be CCA, which contains arsenic. EPA says CCA lumber for homeowner uses stopped being made in December 2003.
  • For the seed surface, use untreated cedar, metal mesh or recycled plastic lumber. The end tag on new lumber names the preservative, so read it before you cut.

No, not for any part that touches seed. The companies that make pressure-treated wood say so themselves. Their consumer safety sheets read: "Do not use pressure-treated wood in circumstances where the preservative may become a component of food, animal feed or beehives." Bird seed in a tray is animal feed.

That rule is about the food, not the feeder. A treated post or deck rail that only holds a feeder up is fine, as long as no seed ever rests on the treated wood.

What pressure-treated wood is#

Pressure-treated wood is lumber that has a pesticide pushed deep into it under pressure. The pesticide is called a preservative, and it is there to stop rot and termites. The National Pesticide Information Center (NPIC) lists a fence, a deck and a garden bed among its home uses.

The treatments sold for home projects now are based on copper. NPIC names three of them:

  • ACQ (alkaline copper quaternary): copper plus a second compound.
  • Copper azole (CA): copper plus a fungicide, a chemical that kills fungi.
  • Micronized copper (MCA or MCQ): tiny copper particles lodged in the wood, not chemically bound to it.

The older type is CCA, chromated copper arsenate. The EPA says it contains chromium, copper and/or arsenic. Makers stopped producing it for homeowner uses in December 2003. It is still used for commercial poles, posts and pilings.

New treated lumber carries an end tag, a small label stapled to the end of the board. NPIC says it lists the preservative and where the wood is meant to go, such as ground contact or above ground. That tag is the quickest way to know what you have.

Why the rule covers seed#

The preservative is meant to stay put, but not all of it does. The copper azole sheet from Deckorators says the preservative will "remain in the wood for a long period of time." It also says "some preservative may migrate from the preserved wood into surrounding soil or water over time." Some may also rub off "upon contact with skin."

Seed on a tray sits in exactly that zone, wet by rain, rubbed by feet and left in place for hours. Whatever comes off the wood has nowhere to go but into the seed. That is the situation the food and feed line is written for.

The copper did not change the rule#

This is where most advice online goes wrong. The common claim is that old treated wood had arsenic, new wood does not, so new wood is fine.

The first half is true, but the second half is not what the makers say. We checked a copper azole sheet (Deckorators) and a micronized copper azole sheet (Koppers MicroPro). Both carry the same line: "Do not use preserved wood under circumstances where the preservative may become a component of food, animal feed, or beehives." The industry site treatedwood.com uses it too.

So the switch from arsenic to copper changed what is in the wood. It did not change where the makers say the wood should go.

Worked through: a tray feeder from deck leftovers#

Suppose you have a treated 4x4 left over from a new fence. You also have some old boards from a deck built in the late 1990s. You want a tray feeder on a post. Here is how each part comes out.

  1. The post. A treated 4x4 in the ground holds the feeder up. No seed sits on it, so the food rule does not apply. This part is fine, but a square wooden post is easy for raccoons and squirrels to grip and climb. It needs a baffle, set as worked out in baffles and poles.
  2. The post top. Do not let seed pile on the cut end of the post. Mount the tray on a block or bracket so the post is not the floor. The same goes for a deck rail: clamp a feeder to it, but do not scatter seed along it.
  3. The tray floor. This is the seed surface, so no treated wood. The old deck boards are worse still. A deck from the 1990s predates the 2003 change, so they may be CCA, and the tag is long gone. Use a frame of untreated cedar with a metal mesh floor. Mesh also drains, which matters more than the wood, as the platform tray guide explains.
  4. The rim. The seed sits against it, so it counts as a seed surface. Untreated cedar again.
  5. A roof, if you add one. Rain runs off a roof and drips into the tray. The sheets say preservative may migrate into water, so a treated roof over an open tray is a way to wash it into the seed. Use untreated wood or metal.
  6. The offcuts. Do not burn them. All five sources on this page say so.

The result: a treated post, an untreated tray. That split is the whole answer.

Part by part#

PartTreated wood?Why
Post or pole holding a feederYesNo seed touches it; baffle it for climbers
Deck rail with a feeder clamped onYesThe feeder holds the seed, not the rail
Seed spread on a rail or post topNoSeed on treated wood: the food and feed line
Tray floor, rim, hopper ledge or wallsNoSeed surface: the food and feed line
Roof over an open trayNoRain carries preservative into the seed
Old deck boards, any seed surfaceNoMay be CCA (pre-2004) and untagged

What to use instead#

For the parts that touch seed, pick from materials the site already covers in bird feeder materials:

  • Untreated cedar. It resists rot on its own and is the traditional feeder wood. It soaks up seed oil and cannot take a bleach soak, so scrub it and replace it when it turns greasy.
  • Metal mesh. The best tray floor anyway, because water passes through and the seed dries.
  • Recycled plastic lumber. It does not rot, and it takes the bleach soak from how to clean a bird feeder.

NPIC lists untreated hardwoods, concrete and plastics as the usual substitutes for treated wood. Any of them will do for a stand or a base, too, if you would rather avoid treated wood entirely.

If you are building a hopper feeder, the same split holds. The roof and outer walls never touch seed, but in a hopper the inside walls do, so keep the whole seed box untreated. On a suet feeder, the tail-prop board that woodpeckers lean on should be untreated too, since fat smears into it.

Old decks and reclaimed lumber#

A deck, fence or play set built before 2004 may be CCA. EPA does not require anyone to tear these out. It says a penetrating stain, applied regularly, may reduce what leaches out.

That advice is for living with an old deck. It is not a reason to put seed on one, so if you scatter seed on old deck boards for ground-feeding birds, put down a tray first. NPIC also notes that EPA does not regulate the reuse of treated wood, so nobody has assessed what reclaimed boards give off. Keep them out of the feeder.

Why the advice online splits#

You will read both "it's fine" and "never" about the same board.

The "fine" answers are usually right that modern lumber has no arsenic. They skip the next step, which is the makers' own food and feed line.

The "never" answers are right about the tray but go too far on the rest. A treated post holding a feeder is not covered by the rule. Its real drawback is that animals climb it, and a baffle deals with that.

What this answer does not cover#

No study we found measured preservative moving from treated wood into bird seed, or harm to wild birds from eating off it. The answer here rests on the makers' own use restriction, not on a measured dose. It is a reason to keep treated wood away from seed. It is not proof that a bird that ate from a treated tray was harmed.

This page reads the copper treatments and CCA. Oil-based preservatives, such as creosote on old railroad ties, are a different case. NPIC says creosote is not sold for use at home, so keep any such wood well away from a feeding area.

Bird baths, nest boxes and garden beds are outside this page. For water, start with bird baths and water. If a wooden tray has already gone dark and greasy, it has a problem that has nothing to do with treatment, covered in moldy seed. For a wooden feeder that is coming apart, see feeder repair and maintenance.

Wear gloves and a dust mask when you cut treated wood, and wash your hands after. The sheets ask for that whatever you build. Then mount the finished feeder as set out in poles, hooks and hangers.

Frequently asked questions#

Is it OK to mount a bird feeder on a pressure-treated 4x4 post?

On the chemistry, yes. The safety sheets rule out treated wood where the preservative may become part of food or animal feed, and a post that only holds the feeder up does not do that. Keep the seed off the post top. The bigger problem with a wooden post is climbing: raccoons and squirrels grip it easily, so it needs a baffle sized for the animals you have.

Is new pressure-treated wood safer than old pressure-treated wood?

It has no arsenic, which matters. EPA says makers stopped producing CCA lumber for homeowner uses in December 2003, and new home lumber is treated with copper compounds instead. But the copper azole and micronized copper safety sheets carry the same line as the old ones: do not use the wood where the preservative may become part of food or animal feed. So for a seed tray, new treated wood is still a no.

Can I build a bird feeder from old deck boards?

Not the parts that touch seed. Boards from a deck built before 2004 may be CCA, which contains arsenic, and there is often no tag left to tell you. NPIC notes that EPA does not regulate the reuse of treated wood, so nobody has assessed what reused boards release. Use them for a stand or a post if you like, and build the tray from untreated wood, metal mesh or recycled plastic lumber.

Can I paint or seal treated wood so it is safe for a feeder tray?

We found no source that says a coating makes treated wood fit for food or feed contact. EPA says a regular penetrating stain may reduce leaching from an old CCA deck, which is not the same thing. Birds also peck at the surface they eat from, and our materials guide already advises against sealing the inside of a feeder. Build the tray from something that was never treated.

Is cedar treated?

Not usually. Cedar resists rot on its own, which is why it is the traditional feeder wood and why it is normally sold untreated. Treated lumber carries an end tag that names the preservative, so look for one on the board or the bundle. If you cannot tell, ask the lumber yard before you buy, and use the board for the seed surface only once you know.

What should I do with treated wood offcuts from a feeder project?

Do not burn them, in a fire pit, stove or fireplace. EPA, NPIC and the industry sheets all say so. Sweep up the sawdust, since the sheets ask for that too, and do not put it on garden beds as mulch. Small offcuts can usually go out with household trash, but check local rules, which EPA notes can differ by state or town.

Sources and further reading

  1. Safe Handling Practices for Treated Wood Viance, treatedwood.com (industry consumer information) Do not use pressure-treated wood where the preservative may become a component of food, animal feed or beehives; no mulch; no burning; no drinking water contact except incidental contact such as docks and bridges; gloves, dust mask and goggles, wash hands
  2. Copper Azole Type B Pressure-Treated Wood: Safe Handling Information (15903, 2/26) Deckorators, Inc. Preservative penetrates deeply and remains a long time, but some may migrate into surrounding soil or water and dislodge on contact with skin; same food, animal feed and beehive line; do not burn; use only visibly clean wood for decks and walkways
  3. Treated Wood Care and Maintenance (MicroPro, micronized copper azole) Koppers Performance Chemicals Important Information panel: same food, animal feed and beehive line; no mulch; do not burn; preservative may migrate into soil or water
  4. Chromated Arsenicals (CCA) US Environmental Protection Agency CCA contains chromium, copper and/or arsenic; manufacture for homeowner uses stopped December 2003; still used for commercial poles, posts and pilings; removal of old structures not required; penetrating stain may reduce leaching; do not burn
  5. Treated Wood Fact Sheet National Pesticide Information Center (Oregon State University and US EPA) What treated wood is; ACQ, copper azole and micronized copper defined; end tag names the preservative and use category; reuse of treated wood not regulated by EPA; substitutes include untreated hardwoods, concrete and plastics; most leaching in the first few months